Ronseal Total Wood Preserver

Ronseal Total Wood Preserver:- is great at preventing rot and decay and wood discolouring fungi like blue stain. It also protects against woodworm infestation. PLEASE NOTE: RONSEAL TOTAL WOOD PRESERVER DOES NOT PROVIDE WATERPROOFING PROTECTION

-Coverage Up to 9.6 sq m per litre

-Application Brush

-Drying 24 Hours

-Finish Matt

BEFORE YOU START

Make sure the surface you’re protecting is clean, dry and free from any coatings like paint, varnish or stain. You’ll need to strengthen any decayed wood with Ronseal Wet Rot Wood Hardener. Once this has hardened, you’ll be able to repair the wood with Ronseal High Performance Wood Filler.

USING YOUR PRESERVER

Give the tin a good shake. You can either brush, spray it on or dip apply. For the end grains, we’d recommend dipping to make sure that the preserver completely soaks into the wood. You’ll need to add at least two coats, waiting 24 hours between them. If you need to carry out any repairs or gluing, wait until the second coat is completely dry.

CLEAN UP

Remove as much preserver off your brush as you can then clean with a brush cleaner. Don’t empty any left over preserver into drains or watercourses. Your local authority may have special ways to get rid of unused paints.

HOW TO RECOGNISE DRY ROT:

Dry rot might appear as white, fluffy, cotton wool like growths or in white or grey sheets. You may also find grey or white branching strands, up to 6mm wide spreading on brickwork or behind plaster. Rusty red, pancake shaped, fruit bodies can also mean that you have a dry rot problem. Wood under attack from dry rot shrinks and splits in large, brick shaped pieces across the grain and is dry and brittle.

HOW TO RECOGNISE WET ROT:

Wet rot is a fungal attack and can cause the surface of the wood to darken. Decayed wood splits along the grain and smaller cubes of wood are formed as a result. The wood may also become soft and spongy. Thin, brown, branching strands of fungi may form on the surface of the timber under attack.

HOW TO RECOGNISE INSECT ATTACK:

Insect attack can be recognised by small, round flight holes on the surface of the wood or by tunnels in the wood. New holes will show clean, fresh timber inside them and fine, gritty powder can be seen on the surface or beneath the site of activity.