Ronseal Thompsons Waterseal

Thompson's Water Seal- uses a unique micro silicone emulsion to stop water penetration. Apply Water Seal directly onto damp surfaces to provide long lasting waterproof protection within hours.

Preperation- give the surface a decent scrub with a stiff bristle brush. Fill any cracks and do pointing repairs, if needed.

Application- give the tin a good shake. Apply using a brush or roller. If you're tackling a wall, work in 1m sections from the bottom upwards. Once an area is fully saturated move onto the next section. Don't forget to give those mortar lines a soaking too. Make sure you treat the whole wall and not just isolated areas. As soon as the first coat has soaked in, you can crack on with the second. Use at full strength. Do not dilutecoat.

Clean Up- clean your equipment in warm water and detergent

Coverage- Thompson’s Water Seal will cover approximately 4 m² per litre. Coverage will vary depending on the texture and porosity of the surface to being treated.

Drying Time- Thompson’s Water Seal should be dry in 2 hours under normal conditions. Dry times depend on the texture & type of surface you’re coating.